Boiler Breakdown Advice

I have listed some of the most typical boiler breakdown problems below to obtain the boiler backup and working.

You wake up one morning looking to jump in the shower only to find you haven't any warm water, you go and check the boiler and notice a fault code is showing on the display, just what exactly do you do?

You need to discover what the fault code is and why it has made the boiler breakdown.

All boilers are supplied with a users manual, inside this manual will undoubtedly be listed all of the fault codes and the explanation for the code to display.

The fault code reason is only a guide on which to check on for, sometimes it can be quite a mix of problems, but it's a starting place to try and trace the problem.

Sometimes it's a magic pill simply by pushing the reset button, other times it can be a bit more involved.

Most boiler breakdown fault codes could be avoided just by maintaining your boiler frequently.

All boiler manufactures recommend having a boiler service carried out each year to keep the boiler working since it was designed for.

Best boiler repair company in South London  is just like an automobile engine, if left un-serviced it will eventually breakdown and could possibly be costly to correct.

One of the most common boiler problems is low water pressure, that is due to the water within the whole of the system dropping to a spot where the boiler sensor senses low water and throws up a fault code and locks the boiler out.

Low water pressure often means many things, it may be a leak somewhere on the system, a radiator valve leaking or perhaps a leak on a pipe somewhere.

The most common answer to this problem may be the expansion vessel. If your boiler has been working with no problems going back after some duration, then all of a sudden you see the water pressure must be topped up every now and then, the chances will be the expansion vessel needs checking.

The expansion vessel is like a balloon, as time passes it'll loose its pressure and water will enter the vessel, once this happens you may have a boiler breakdown with a fault code displaying on the boiler screen.

The expansion vessel is a very important part of the boiler and needs to be maintained each year.

Another common boiler breakdown is because of dirty water, that is caused when no inhibitor is added to the system water.

You might have noticed if you have ever vented a radiator that the water is quite dirty as it pertains out from the vent, this normally indicates no inhibitor within the system, even if inhibitor was added, overtime it'll dilute down and will must be topped up, this should be checked each year.

The dirty water will eventually block up the boiler heat exchanger, this cause the boiler to overheat and go to lockout.

Have you ever encounter a boiler breakdown when it's snowing outside even freezing?

Most boilers these days are condensing boilers, and when the boiler is working it produces condense.

The condense must exit into a drain, internally is preferable, but sometimes the condense pipe would go to another drain, if this is the case the pipe must be protected from the cold with pipe lagging.

Should the condense pipe freeze over, the condense will start to back up into the boiler and eventually the boiler will breakdown, with a fault code displaying on the boiler display.

These are just a few the most typical boiler breakdown faults that could be avoided if only you'd the boiler serviced.

Boilers do breakdown even though serviced each year, however, not up to a boiler not serviced.

Always have your boiler serviced every year by way of a Gas Safe Registered company, avoid Joe Bloggs from down the road just because he could be cheaper.

All Gas Safe Engineers have to re-sit their gas exams every five years to carry on working within the gas industry.

I hope this advice can help you keeping in mind your boiler working and producing all the heat and warm water you need.